Toyota Corolla Cross: Wiper / Washer
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY (a) for LH Side: (1) Operate the windshield wiper motor assembly.
(2) Stop the windshield wiper motor assembly operation.
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FRONT WIPER ARM HEAD CAP
85292B
- -
2 FRONT WIPER ARM AND
SEE MORE:
MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 (14°F) or higher, and less than 50°C (122°F). If certain conditions are met, a DTC is stored after the engine idles for 15 seconds (2 trip detection logic).
This DTC is designed to monitor
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cylinder head gasket removal/installation are shown below. Necessary Procedures After Parts Removed/In
