Toyota Corolla Cross: Wiper And Washer System
READ NEXT:
PRECAUTION PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged. (2) Ad
PARTS LOCATION ILLUSTRATION
*A w/ Washer Fluid Level Warning System
- -
*1 WINDSHIELD WIPER MOTOR ASSEMBLY
*2 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
*3 LEVE
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM
REAR WIPER SYSTEM (w/ Rear Wiper System)
WASHER FLUID LEVEL WARNING SYSTEM (w/ Level Warning Switch)
SEE MORE:
■ Location of air outlets
The air outlets and air volume
changes according to the
selected air flow mode.
■ Adjusting the position of
and opening and closing
the air outlets
Front center
Direct air flow to the left or right, up
or down
Front right-hand side
Direct air flow to the left or
r
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Using a dial indicator, measure the runout of the intermediate shaft
assembly.
Maximum Runout:
0.6 mm (0.0236 in.)
NOTICE:
The dial indicator must be set at a right angle to the center of