Toyota Corolla Cross: Precaution
PRECAUTION
PRECAUTION FOR WASHER NOZZLE ADJUSTMENT
(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:
(1) The washer nozzle tip is made of resin and may be damaged.
(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.
Click here .gif)
(b) If the washer nozzle is clogged with wax, etc., remove it and clean the nozzle hole with a soft resin brush or other cleaning tool.
READ NEXT:
PARTS LOCATION ILLUSTRATION
*A w/ Washer Fluid Level Warning System
- -
*1 WINDSHIELD WIPER MOTOR ASSEMBLY
*2 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
*3 LEVE
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM
REAR WIPER SYSTEM (w/ Rear Wiper System)
WASHER FLUID LEVEL WARNING SYSTEM (w/ Level Warning Switch)
SYSTEM DESCRIPTION FRONT WIPER CONTROL FUNCTION
Control/Function Description
INT function*1 Operates the wipers intermittently at LO speed when the front wiper switch is in the INT po
SEE MORE:
DTC SUMMARY MALFUNCTION DESCRIPTION The hybrid vehicle control ECU detects that a safety device (interlock) is operated or that there is an open circuit in the detection circuit. (Even if an open circuit occurs while the vehicle is stopped, the system determines that the safety device was operated.)
DESCRIPTION
The airbag ECU assembly has a built-in yaw rate and acceleration
sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) memorizes the
range of the acceleration sensor (airbag ECU assembly) and the range of vehicle
speed calculated using each spee
