Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Freeze Frame Data

FREEZE FRAME DATA

HINT:

  • Freeze frame data is stored at the time when DTCs are detected.
  • When freeze frame data at the time it is stored that a DTC is detected, data is not updated or cleared until the stored data is cleared (Clear DTCs).

CHECK FREEZE FRAME DATA

(a) According to the display on the GTS, display the freeze frame data for the selected DTC.

Chassis > Rear Camera

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Total Distance Traveled

Total distance traveled

1 to 999999

Same as actual total distance traveled

For the unit, refer to "Total Distance Traveled - Unit"

Total Distance Traveled - Unit

Total distance traveled unit

km or mile

km: km

mile: mile

-

Steering Angle

Steering angle

-3276.8 to 3276.7 deg

Steering left: Changes positively continuously

Steering right: Changes negative continuously

-

Vehicle Speed

Vehicle speed

0 to 655.35 km/h

Equivalent to actual vehicle speed

-

EPS Steering Angle Value

EPS steering angle value

-3276.8 to 3276.7 deg

Steering left: Changes positively continuously

Steering right: Changes negative continuously

-

Target Steering Angle Value (SBW)

Target steering angle value (SBW)

-3276.8 to 3276.7 deg

Steering left: Changes positively continuously

Steering right: Changes negative continuously

-

CLEAR FREEZE FRAME DATA

NOTICE:

Clearing the DTCs will also clear the freeze frame data.

(a) Clear the DTCs and freeze frame data.

Chassis > Rear Camera > Clear DTCs

    READ NEXT:

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when decidi

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Parking Assist Monitor System DTC No. Detection Item Link C161704 Camera Malfunction System Internal Failur

     VEHICLE CONTROL HISTORY (RoB)

    VEHICLE CONTROL HISTORY (RoB) NOTICE: When checking the vehicle control history, first store the output history and then check the history. HINT: Depending on the specifications of the vehicle,

    SEE MORE:

     Generator Position Sensor Signal Amplitude < (P0A4B21,P0A1A47,P0A4B22,P1C2A49)

    DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Inverter low-voltage circuit The connectors are not connected properly H

     Terminals Of Ecu

    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY (a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assembly. Click here (b) Connect the power distribution box assembly connectors. (c) Measure the volt

    © 2020-2025 Copyright www.tcorollacross.com