Toyota Corolla Cross: Washer Motor
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FRONT WHEEL RH
- -
- -
2 FRONT FENDER MOULDING SUB-ASSEMBLY RH
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
HINT: This check should be performed with the windshield washer motor and pump assembly installed to the windshield washer ja
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
85310 -
- -
2
SEE MORE:
Inspection
INSPECTION
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after completing the front wheel alignment procedure are
shown below.
Necessary Procedures After Procedure Performed
Replaced
The RCTA function uses the
BSM rear side radar sensors
installed behind the rear
bumper. This function is
intended to assist the driver
in checking areas that are
not easily visible when
backing up.
WARNING
■Cautions regarding the use of
the system
The driver is solely responsible for
safe driving
Removal
Rear Wheel Alignment (for 2wd)
