Toyota Corolla Cross: Rear Wiper Motor
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT REAR WIPER MOTOR ASSEMBLY (a) Operate the rear wiper motor assembly.
(b) Stop the rear wiper motor assembly operation.
(c) Check the automatic stop po
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 UPPER BACK DOOR TRIM PANEL ASSEMBLY
64790B -
- -
2 BACK DOOR SID
INSPECTION PROCEDURE 1. INSPECT REAR WIPER MOTOR ASSEMBLY
(a) Check that the rear wiper motor assembly operates.
(1) Apply auxiliary battery voltage to the rear wiper motor connector and check t
SEE MORE:
DESCRIPTION The engine stop and start ECU determines changes in the brake booster assembly pressure based on the voltage signal received from the vacuum sensor assembly in the brake booster assembly.
If the engine stop and start ECU judges that the signal received from the vacuum sensor assembly i
INSPECTION PROCEDURE 1. INSPECT CYLINDER BLOCK FOR WARPAGE
(a) Using a precision straightedge and feeler gauge, check the surface which contacts the cylinder head gasket for warpage.
Maximum Warpage: 0.05 mm (0.00197 in.) HINT: If the warpage is more than the maximum, replace the cylinder
On-vehicle Inspection
Brake Booster Pressure Sensor Circuit Short to Ground (P055511,P055515)
