Toyota Corolla Cross: Lighting System (w/ Afs)
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Freeze Frame Data
- Data List / Active Test
- Diagnostic Trouble Code Chart
- VEHICLE CONTROL HISTORY (RoB)
- Light Sensor Circuit Malfunction (B124400)
- Swivel Motor LH Missing Message (B241087,B241187)
- Swivel Motor LH Malfunction (B241200,B241300,B241700,B241800)
- Rear Height Sensor Circuit Voltage Out of Range (B241A1C)
- Leveling Motor LH Missing Message (B242487,B242587)
- Headlight Control Module (Sub) System Internal Failure (B242C04,B242D04)
- IG Circuit Short to Ground or Open (B242E14)
- ECUB Circuit Short to Ground or Open (B242F14)
- Headlight Source LH Malfunction (B243900,B243A00)
- Low Beam LH Circuit Voltage Out of Range (B24441C,B24451C)
- Lost Communication With ECM/PCM "A" Missing Message (U010087,...,U111787)
- Lost Communication with TCM Missing Message (U010187,U010087,U012987,U013187,U014087,U015587,U024287,U029387)
- Lost Communication with Steering Angle Sensor Module Missing Message (U012687,U012987,U014087,U015587,U024187)
- CAN Register Fixing Internal Electronic Failure (U100049)
- Turn Signal Switch Circuit
- Headlight Dimmer Switch Circuit
- Parking Light/Daytime Running Light Circuit
- Front Fog Light Circuit
- Hazard Warning Switch Circuit
- Back-up Light Circuit
- Front Side Marker Light Circuit
- Taillight Relay Circuit
- High Beam Headlight Circuit
READ NEXT:
PRECAUTION REPLACEMENT PRECAUTIONS (a) When replacing the headlight ECU sub-assembly LH, always replace it with a new one. If a headlight ECU sub-assembly LH which was installed to another vehicle is
PARTS LOCATION ILLUSTRATION
*1 HEADLIGHT UNIT ASSEMBLY LH
*2 HEADLIGHT UNIT ASSEMBLY RH
*3 SIDE TURN SIGNAL LIGHT ASSEMBLY LH
*4 SIDE TURN SIGNAL LIGHT ASSEMBLY RH
SYSTEM DIAGRAM Daytime Running Light
Light Auto Turn-off System
Automatic Headlight Beam Level Control System
Intelligent Adaptive Front-lighting System (AFS)
Extended Headlight Lighting Syste
SEE MORE:
DESCRIPTION
When the automatic high beam system is on, the main body ECU
(multiplex network body ECU) illuminates the auto high beam switch indicator.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following
DESCRIPTION The BIN resistance is equipped for the purpose of correcting variances in brightness (luminous flux) when the light control LED ECU is energizing the LED with a constant current to illuminate it.
Also, it monitors the voltage applied to the BIN resistance in order to detect abnormalitie