Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Definition Of Terms

DEFINITION OF TERMS

Term

Definition

Monitor Description

Description of what the ECM monitors and how it detects malfunctions (monitoring purpose and details).

Related DTCs

Group of diagnostic trouble codes that are output by the ECM based on the same malfunction detection logic.

Typical Enabling Conditions

Preconditions that allow the ECM to detect malfunctions.

With all preconditions satisfied, the ECM stores a DTC when the monitored value(s) exceeds the malfunction threshold(s).

Sequence of Operation

The priority order that is applied to monitoring if multiple sensors and components are used to detect the malfunction.

While one sensor is being monitored, the next sensor or component will not be monitored.

Required Sensors/Components

The sensors and components that are used by the ECM to detect malfunctions.

Frequency of Operation

The number of times that the ECM checks for malfunctions per driving cycle.

"Once per driving cycle" means that the ECM detects a malfunction only once during a single driving cycle.

"Continuous" means that the ECM detects a malfunction every time the enabling conditions are met.

Duration

The minimum time for which the ECM must detect a continuous deviation in the monitored value(s) in order to store a DTC. Timing begins after the "typical enabling conditions" are met.

Typical Malfunction Thresholds

Value beyond which the ECM will determine that there is a malfunction and store a DTC.

MIL Operation

MIL illumination timing after a malfunction is detected.

"Immediate" means that the ECM illuminates the MIL the instant the ECM determines that there is a malfunction.

"2 driving cycles" means that the ECM illuminates the MIL if the same malfunction is detected again in the next driving cycle.

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 FUEL PUMP (for Low Pressure Side) *2 MASS AIR FLOW METER SUB-ASSEMBLY *3 ECM *4 NO. 1 ENGINE ROOM RELAY BLOCK *5 FUEL PUM

     System Diagram

    SYSTEM DIAGRAM

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT 2. CUSTOMER PROBLEM ANALYSIS NEXT

    SEE MORE:

     Hybrid/EV Battery Current Sensor "A" Signal Stuck In Range (P0ABF2A)

    DESCRIPTION Refer to the description for DTC P0ABF11. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate Note P0ABF2A Hybrid/EV Battery Current Sensor "A" Signal Stuck In Range The hybrid battery voltage i

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the GTS to read the Data List allows the values or states of swit

    © 2020-2025 Copyright www.tcorollacross.com PT NL