Toyota Corolla Cross: Hazard Warning Switch
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
55405B -
- -
2
INSPECTION PROCEDURE 1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY
(a) Check that the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistanc
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 HAZARD WARNING SIGNAL SWITCH ASSEMBLY
84380 -
- -
2 CE
SEE MORE:
DESCRIPTION If the ignition switch is ON, the hybrid vehicle control ECU applies current to the MREL terminal to turn the IGCT relay on. This supplies power to the +B1 terminal. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
After the ignition switch is turned off, there may be a waitin
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.
HINT