Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Brake System Control Module "A" System Internal Failure (C059704)

Toyota Corolla Cross (2022-2025) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Brake System Control Module "A" System Internal Failure (C059704)

DESCRIPTION

The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self-diagnosis.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C059704

Brake System Control Module "A" System Internal Failure

Internal failure of the skid control ECU (brake actuator assembly).

Skid control ECU (brake actuator assembly)

PROCEDURE

1.

REPLACE BRAKE ACTUATOR ASSEMBLY

Click here

NEXT

END

    READ NEXT:

     Brake System Control Module "A" Calibration / Parameter Memory Failure (C059746)

    DESCRIPTION If the system information stored by the skid control ECU (brake actuator assembly) is corrupted, this DTC is output. DTC No. Detection Item DTC Detecti

     ABS Pump Motor Drive Circuit Supply Voltage Circuit Voltage Below Threshold (C116516)

    DESCRIPTION The ABS motor relay is built into the brake actuator assembly. When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC, brake hold or brake assist, the ABS motor re

     ABS Operation Continuous Request (C116E63,C116F63,C124E62)

    DESCRIPTION The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from each speed sensor. These signals are used for recognizing that all four wheels

    SEE MORE:

     Left Front Wheel Speed Sensor Internal Electronic Failure (C050049)

    DESCRIPTION When the system is starting up and the skid control ECU (brake actuator assembly) detects a speed sensor circuit malfunction via the speed sensor circuit self-diagnosis function, this DTC is stored. DTC No. Detection Item DTC Detection Condition

     Brake Hold Switch

    Inspection INSPECTION PROCEDURE 1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection

    © 2020-2025 Copyright www.tcorollacross.com PT NL