Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Brake System Control Module "A" Calibration / Parameter Memory Failure (C059746)

Toyota Corolla Cross (2022-2025) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Brake System Control Module "A" Calibration / Parameter Memory Failure (C059746)

DESCRIPTION

If the system information stored by the skid control ECU (brake actuator assembly) is corrupted, this DTC is output.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C059746

Brake System Control Module "A" Calibration / Parameter Memory Failure

After the ignition switch is turned to ON (IG) and the rotor position sensor calibration test is performed, it is detected that the obtained offset value is outside of the specified range.

Skid control ECU (brake actuator assembly)

PROCEDURE

1.

REPLACE BRAKE ACTUATOR ASSEMBLY

Click here

NEXT

END

    READ NEXT:

     ABS Pump Motor Drive Circuit Supply Voltage Circuit Voltage Below Threshold (C116516)

    DESCRIPTION The ABS motor relay is built into the brake actuator assembly. When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC, brake hold or brake assist, the ABS motor re

     ABS Operation Continuous Request (C116E63,C116F63,C124E62)

    DESCRIPTION The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from each speed sensor. These signals are used for recognizing that all four wheels

     Multi-axis Acceleration Sensor Module "A" Supply Voltage (2WD) Circuit Voltage Out of Range (C11791C,C14D71C)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. This DTC is stored when the skid control ECU (brake actuator assembly) rece

    SEE MORE:

     Diagnosis System

    DIAGNOSIS SYSTEM DESCRIPTION (a) The transponder key ECU assembly controls the immobiliser system. Immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). CHECK DLC3 (a) Check the DLC3. Click here INSPECT AUXILIARY BATTERY VOLTA

     A/C Switch Indicator does not Turn On

    DESCRIPTION If none of the switch indicators on the air conditioning control assembly illuminate, the following factors may be the cause. Symptom Factor A/C switch indicator does not illuminate Air conditioning amplifier assembly malfunction Air conditioning control

    © 2020-2025 Copyright www.tcorollacross.com PT NL