Toyota Corolla Cross: Air Fuel Ratio Sensor (for Sensor 2)
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 WIRING HARNESS CLAMP BRACKET
82715W
- -
2 NO. 2
INSPECTION PROCEDURE 1. INSPECT NO. 2 AIR FUEL RATIO SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 NO. 2 AIR FUEL RATIO SENSOR
89467C
- -
2
SEE MORE:
DESCRIPTION
The ABS motor relay is built into the brake actuator assembly.
When the skid control ECU (brake actuator assembly) operates
ABS, TRAC, VSC, brake hold or brake assist, the ABS motor relay turns ON and drives
the motor pump built into the brake actuator assembly.
If the voltage sup
DESCRIPTION
After turning the ignition switch to ON, the DCM (telematics
transceiver) will enter into self check mode. The manual (SOS) switch red indicator
will illuminate for 2 seconds and turn off followed by the manual (SOS) switch green
indicator illuminating and remaining on under norma
Removal
ABS Pump Motor Drive Circuit Supply Voltage Circuit Voltage Below Threshold
(C116516)
