Toyota Corolla Cross: Steering Angle Sensor Module Component Internal Failure (C052696)

Toyota Corolla Cross (2022-2026) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Steering Angle Sensor Module Component Internal Failure (C052696)

DESCRIPTION

This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering sensor.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C052696	Steering Angle Sensor Module Component Internal Failure	With the +BS terminal voltage between 9.6 and 16.5 V, a steering sensor internal malfunction signal is received from the steering sensor.	Steering sensor

PROCEDURE

1.	REPLACE STEERING SENSOR

Click here

END

SEE MORE:

Freeze Frame Data

FREEZE FRAME DATA FREEZE FRAME DATA HINT: When a DTC is stored, the freeze frame data stores the current vehicle (sensor) state. The freeze frame data cannot be cleared or updated until the recorded DTCs are cleared. (a) Using the GTS, the state of the vehicle (sensors) when the

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom

Toyota Corolla Cross: Steering Angle Sensor Module Component Internal Failure (C052696)

READ NEXT:

ABS Pump Motor Control Circuit Short to Ground (C052C11,...,C142796)

ABS Pump Motor Control Internal Electronic Failure (C052C49)

Brake Pressure Sensor "A" Circuit Voltage Out of Range (C05401C,...,C054096)

SEE MORE:

Freeze Frame Data

Problem Symptoms Table