Toyota Corolla Cross: Slip Indicator Light does not Come ON

Toyota Corolla Cross (2022-2026) Service Manual / Brake / Brake Control / Dynamic Control Systems / Electronically Controlled Brake System (for Gasoline Model) / Slip Indicator Light does not Come ON

DESCRIPTION

The skid control ECU (brake actuator assembly) controls the slip indicator light in the combination meter assembly via CAN communication.

PROCEDURE

1.	INSPECT COMBINATION METER ASSEMBLY

(a) Perform the Active Test of the combination meter assembly using the GTS.

Click here

Body Electrical > Combination Meter > Active Test

Tester Display
Slip Warning

(b) Check the combination meter assembly.

OK:

The slip indicator light turns on or off in accordance with GTS operation.

REPLACE BRAKE ACTUATOR ASSEMBLY

INSPECT METER / GAUGE SYSTEM

SEE MORE:

Blower Motor does not Operate

DESCRIPTION If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause. Symptom Factor Blower motor does not operate at all (Air does not blow from registers)

Inspection

INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY (a) for LH Belt: (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition O85-5(LBR+) - O85-4(LBR-) R

Toyota Corolla Cross: Slip Indicator Light does not Come ON

READ NEXT:

Steering Angle Sensor Wrong Installation (X0455)

Yaw Rate Sensor Wrong Installation (X0456)

Zero Point Calibration of Yaw Rate Sensor Undone (X204C)

SEE MORE:

Blower Motor does not Operate

Inspection