Toyota Corolla Cross: Shift Stroke Sensor
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
INLET NO. 1 AIR CLEANER
1775
INSPECTION
PROCEDURE
1. INSPECT SHIFT STROKE SENSOR
(a) Connect 3 new dry-cell batteries (1.5 V each) in series.
(b) Prepare a magnet or equivalent tool.
(c) Connect a positive (+) lead from the
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
SHIFT STROKE SENSOR
SEE MORE:
DTC CHECK / CLEAR OUTLINE
After clearing current DTCs using the GTS (or by disconnecting the cable from the negative (-) auxiliary battery terminal), permanent DTCs can be cleared when the universal trip is performed and then the system is determined to be normal for the relevant DTCs. The driv
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following menus: Chassis / Brake/EPB / Active Test.
HINT:
Refer to the GTS operator's manual for further
Removal
Dtc Check / Clear
