Toyota Corolla Cross: Refrigerant Line
READ NEXT:
COMPONENTS ILLUSTRATION
*A for Gasoline Model
- -
*1 PIPING CLAMP
*2 SUCTION PIPE SUB-ASSEMBLY
*3 SUCTION HOSE SUB-ASSEMBLY
*4 DISCHARGE HOSE SU
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Click here 2. REMOVE PIPING CLAMP (for Suction Hose Sub-assembly)
(a) for Gasoline Model: (1) While pressing the end of the suc
INSTALLATION PROCEDURE 1. INSTALL PIPING CLAMP (for Suction Hose Sub-assembly)
(a) for Gasoline Model: (1) Remove the vinyl tape from the suction pipe sub-assembly and suction hose sub-assembly.
SEE MORE:
DESCRIPTION
The brake pedal load sensing switch (brake pedal support assembly)
turns on when the brake pedal is depressed with a force exceeding a predetermined
level.
The skid control ECU (brake actuator assembly) uses this circuit
to detect if the brake pedal is depressed or not.
DESCRIPTION HINT: These DTCs relate to the accelerator pedal position sensor.
Refer to DTC P212012. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P21201C Throttle/Pedal Position Sensor/Switch "D" Circuit Voltage Out of Range
Components
Brake Pedal Switch "A" Circuit Open (C004013)
