Toyota Corolla Cross: Precaution
	
						
			PRECAUTION
 PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
 
NOTICE:
 After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
 
Click here .gif) 
 
 HINT:
 When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
 
Click here .gif) 
 
 POWER WINDOW CONTROL SYSTEM PRECAUTIONS
 
NOTICE:
	- The power window control system uses the LIN communication system and CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
	Click here .gif)  
 
- The power window control system prohibits the auto up and down functions if the jam protection function or catch protection function malfunctions.
	
- If a power window regulator motor assembly has been replaced with a new one, initialize a power window control system.
	Click here .gif)  
 
- If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.
	Click here .gif)  
 
- The jam protection function or catch protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
	
		- A power window is being opened or closed while the vehicle is driven on a rough road.
		
- A power window is being opened or closed while the door is being opened or closed.
		
- The voltage changes abruptly.
 
- Do not disconnect the cable from the negative (-) auxiliary battery terminal while the ignition switch is ON. If the cable is disconnected from the negative (-) auxiliary battery terminal while the ignition switch is ON, the power window of each seat may become uninitialized.
	Click here .gif)  
 
READ NEXT:
	
   PARTS LOCATION ILLUSTRATION 
 
   
	*A   w/ Smart Key System   
	-   -     
		*1   COMBINATION METER ASSEMBLY   
		*2   MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)     
		*3   POWER DISTRIBUTION BOX AS
   
   
 
	
   SYSTEM DIAGRAM 
 Communication Table    
	Transmitting ECU   Receiving ECU   
	Signal   Communication Method     
		Multiplex Network Master Switch Assembly   
		Power Window Regulator Motor Assembly 
   
   
 
	
   CAUTION / NOTICE / HINT 
HINT:
	Use the following procedure to troubleshoot the power window control system.
	
	*: Use the GTS.
 PROCEDURE    
	1.    VEHICLE BROUGHT TO WORKSHOP       
	  
		
NEXT  
   
   
 
   SEE MORE:
	
   ADJUSTMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) 
that must be performed after parts are removed and installed, or replaced during 
the CVT fluid replacement are shown below.
Necessary Procedure After Parts Removed/Installed/
   
   
 
	
   INSTALLATION CAUTION / NOTICE / HINT 
    
	Procedure   Part Name Code   
	   
	   
	     
		1   INSPECT SPIRAL CABLE SUB-ASSEMBLY   
		-    
		    
		-   -     
		2   STEERING SENSOR   
		89245B    
		    
		-   -     
		3   PLACE FRONT WHEELS FACING STRAIGHT AHEAD   
		-