Toyota Corolla Cross: Power Window Control System
READ NEXT:
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE: After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (
PARTS LOCATION ILLUSTRATION
*A w/ Smart Key System
- -
*1 COMBINATION METER ASSEMBLY
*2 MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
*3 POWER DISTRIBUTION BOX AS
SYSTEM DIAGRAM
Communication Table
Transmitting ECU Receiving ECU
Signal Communication Method
Multiplex Network Master Switch Assembly
Power Window Regulator Motor Assembly
SEE MORE:
INSPECTION
PROCEDURE
1. INSPECT GENERATOR W/CLUTCH PULLEY
(a) Hold the center of the generator pulley with clutch, and confirm
that the outer ring turns counterclockwise and does not turn clockwise.
OK:
The outer ring turns counterclockwise and does not turn clockwise.
If
TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY
(a) Disconnect the I67 transponder key ECU assembly connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harness side with the connector disconnected.
Term