Toyota Corolla Cross: Precaution
PRECAUTION
INITIALIZATION
NOTICE:
Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the cooling fan system have been removed/installed or replaced.
Click here .gif)
IGNITION SWITCH EXPRESSIONS
HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|
Ignition Switch off | LOCK |
Off (Lock) |
|
Ignition Switch ACC | ACC |
On (ACC) |
| Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
PARTS LOCATION ILLUSTRATION
*1 FAN WITH MOTOR ASSEMBLY
*2 ECM
*3 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY
- EFI-MAIN NO. 1 FUSE - FAN NO. 2 FUS
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
SEE MORE:
DESCRIPTION Refer to DTC P033511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P03352A Crankshaft Position Sensor "A" Signal Stuck in Range
No crankshaft position sensor signal to the ECM while the engine is running (1 trip
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT V-RIBBED BELT
(a) Check the V-ribbed belt for wear, cracks or other signs of damage.
HINT: If any of the following defects is found, replace the V-ribbed belt.
The V-ribbed belt is cracked.
The V-ribbed belt is wo
