Toyota Corolla Cross: Cooling Fan System
READ NEXT:
PRECAUTION INITIALIZATION NOTICE: Make sure to perform the necessary procedures (adjustment, calibration, initialization, or registration) after parts related to the cooling fan system have been remov
PARTS LOCATION ILLUSTRATION
*1 FAN WITH MOTOR ASSEMBLY
*2 ECM
*3 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 JUNCTION BLOCK ASSEMBLY
- EFI-MAIN NO. 1 FUSE - FAN NO. 2 FUS
SEE MORE:
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following menus: Chassis / Brake/EPB / Active Test.
HINT:
Refer to the GTS operator's manual for further
DESCRIPTION
The skid control ECU (brake actuator assembly) receives stop
light switch assembly signals and uses them to determine whether or not the brakes
are applied.
DTCs may be stored if either of the following occurs:
Stop light switch assembly stuck on malfunction.
The accelerator
