Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT VACUUM SENSOR ASSEMBLY
(a) Connect the GTS to the DLC3.
(b) Start the engine.
(c) Turn the ignition switch off.
(d) Turn the ignition switch to ON.
(e) Turn the GTS on.
(f) Enter the following menus: Powertrain / Stop and Start / Data List / Brake Boost Pressure.
Powertrain > Stop and Start > Data List
|
Tester Display |
| Brake Boost Pressure |
(g) Compare the "Brake Boost Pressure" values before and after the brake pedal was depressed 5 times.
Standard:
Internal pressure changes by 20 kPa (150 mmHg, 5.91 in.Hg) or more.
HINT:
- Standard atmospheric pressure is 101 kPa (758 mmHg, 29.8 in.Hg).
- For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by 1 kPa (8 mmHg, 0.295 in.Hg).
- Atmospheric pressure varies with weather.
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 BRAKE MASTER CYLINDER SUB-ASSEMBLY
47201 -
- -
2 VACUUM
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 VACUUM SENSOR GROMMET
- -
- -
2 VACUUM SENSOR
h1 {color:red;} h2 {color:blue;} h3 {color:green;}
SEE MORE:
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B002913 Right Curtain Deployment Control 1 Circuit Open
One of the following conditions is met:
The airbag ECU assembly detects an open in th
DESCRIPTION
The ABS solenoid relay and solenoid valves are built into the
brake actuator assembly.
The front solenoid valve LH controls the brake fluid pressure
of the front wheel cylinder LH of the vehicle.
When this DTC is stored, the fail-safe function operates and
the ABS solenoid relay