Toyota Corolla Cross: Vacuum Sensor Assembly
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT VACUUM SENSOR ASSEMBLY (a) Connect the GTS to the DLC3.
(b) Start the engine. (c) Turn the ignition switch off. (d) Turn the ignition switch to ON.
(e)
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 BRAKE MASTER CYLINDER SUB-ASSEMBLY
47201 -
- -
2 VACUUM
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 VACUUM SENSOR GROMMET
- -
- -
2 VACUUM SENSOR
SEE MORE:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each symptom
INSPECTION PROCEDURE 1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY
(a) Perform a visual check for any foreign matter on the intake air temperature sensor (thermistor) of the mass air flow meter sub-assembly shown in the illustration.
OK: There is no foreign matter. If the result is not as sp
On-vehicle Inspection
Problem Symptoms Table
