Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY
(a) Connect the GTS to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the GTS on.
(d) Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No.1 Voltage and Accelerator Position Sensor No.2 Voltage.
Powertrain > Engine > Data List|
Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage |
|
Accelerator Position Sensor No.2 Voltage |
(e) Read the values displayed on the GTS.
Standard Voltage:
|
GTS Display | Condition |
Specified Condition |
|---|---|---|
|
Accelerator Position Sensor No.1 Voltage |
Accelerator pedal fully released |
0.5 to 1.1 V |
|
Accelerator pedal fully depressed |
2.6 to 4.5 V | |
|
Accelerator Position Sensor No.2 Voltage |
Accelerator pedal fully released |
1.2 to 2.0 V |
|
Accelerator pedal fully depressed |
3.4 to 4.75 V |
If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.
