Toyota Corolla Cross: Accelerator Pedal
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY (a) Connect the GTS to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the GTS on. (d) Enter the followin
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55606 -
- -
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 ACCELERATOR PEDAL SENSOR ASSEMBLY
78110K
- -
SEE MORE:
DESCRIPTION When the ignition switch is turned to ON, the auxiliary battery voltage is applied to the IGSW terminal of the ECM. The output signal from the MREL terminal of the ECM causes current to flow to the coil of the EFI-MAIN NO. 1 relay, closing the contacts of the EFI-MAIN NO. 1 relay and sup
CALIBRATION
ADJUST PARKING ASSIST MONITOR SYSTEM
(a) The parking assist monitor system can be adjusted using diagnostic
mode.
(b) If the following operations are performed, it is necessary
to perform adjustments and checks using diagnostic mode.
Part Name
Operation
On-vehicle Inspection
ECM Power Source Circuit
