Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Inside rear view mirror

The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view.

Adjusting the height of rear view mirror

The height of the rear view mirror can be adjusted to suit your driving posture.

Adjust the height of the rear view mirror by moving it up and down.

Adjusting the steering wheel and mirrors

WARNING

■Caution while driving

Do not adjust the position of the mirror while driving.

Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.

Anti-glare function

Manual anti-glare inside rear view mirror

Reflected light from the headlights of vehicles behind can be reduced by operating the lever.

Adjusting the steering wheel and mirrors

  1. Normal position
  2. Anti-glare position

Auto anti-glare inside rear view mirror

Responding to the level of brightness of the headlights of vehicles behind, the reflected light is automatically reduced.

Changing automatic anti-glare function mode

On/off

When the automatic anti-glare function is in ON mode, the indicator A illuminates. The function will set to ON mode each time the engine switch is turned to ON.

Pressing the button turns the function to off mode. (The indicator A also turns off.)

Adjusting the steering wheel and mirrors

■To prevent sensor error (vehicles with an auto anti-glare inside rear view mirror)

To ensure that the sensors operate properly, do not touch or cover them.

Adjusting the steering wheel and mirrors

    READ NEXT:

     Outside rear view mirrors

    The rear view mirror's position can be adjusted to enable sufficient confirmation of the rear view. ■When using the outside rear view mirrors in a cold weather When it is cold and the outside rear v

     Opening and closing the windows

     Power windows

    Opening and closing the power windows The power windows can be opened and closed using the switches. Operating the switch moves the windows as follows: Closing One-touch closing* Opening One-to

    SEE MORE:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 25°C (77°F) 120 to 280 kΩ If the result is not as

     Fuel Rail Pressure Sensor (Low) Circuit Short to Battery or Open (P107A15)

    DESCRIPTION Refer to DTC P107A11. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Note P107A15 Fuel Rail Pressure Sensor (Low) Circuit Short to Battery or Open Diagnosis condition: Ignition switch to ON Abnormal cond

    © 2020-2024 Copyright www.tcorollacross.com