Toyota Corolla Cross: Initialization
INITIALIZATION
SERVO MOTOR INITIALIZATION
(a) Press the OFF switch.
(b) According to the GTS display, perform servo motor initialization.
Body Electrical > Air Conditioner > Utility
|
Tester Display |
| Servomotor Initialization |
HINT:
When initialization is started, the AUTO switch indicator will illuminate and then will turn off when initialization has completed.
READ NEXT:
UTILITY REFRIGERANT SHORTAGE CHECK USING GTS (a) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the GTS. Measurement Condition:
PROBLEM SYMPTOMS TABLE
NOTICE:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in ord
TERMINALS OF ECU
CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY
HINT:
Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.
Make sure to wait
SEE MORE:
OPERATION CHECK
HINT:
This function shows the telematics network status when the DCM (telematics
transceiver) was operated. Use this when no DTC is present but this telematics
system was unable to connect to the call center. This symptom may occur
if cell phone signal strength is ve
PARTS LOCATION
ILLUSTRATION
*1
MAP LIGHT ASSEMBLY
- MANUAL (SOS) SWITCH
*2
TELEPHONE MICROPHONE ASSEMBLY
*3
ROOF ANTENNA ASSEMBLY
*4
NO. 2 ANTENNA CORD SUB-ASSEMBLY
*5
NO.
