Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Hood

READ NEXT:

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT HOOD SUB-ASSEMBLY (a) Check that the clearance measurements of areas A through G are within each standard range. Standard Clearance Area Measuremen

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT COMPONENTS (DISASSEMBLY) Procedure Part Name Code 1 HOOD INSULATOR 53341B - - - 2 WASHER NOZZLE SUB-ASSEMBLY

 Adjustment

ADJUSTMENT CAUTION / NOTICE / HINT *a Centering Bolt *b Standard Bolt HINT: Centering bolts are used to install the hood hinges and hood lock. The hood and hood lock cannot be

SEE MORE:

 Inspection

INSPECTION PROCEDURE 1. INSPECT INNER REAR VIEW MIRROR ASSEMBLY (a) Inspect the operation of the inner rear view mirror assembly. *a Black Colored Tape *b Forward Sensor *c Bright *d Dark *e Auxiliary Battery *f EC Switch *g Compone

 Cold Start Ignition Timing Performance (P050B00)

MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 (14°F) or higher, and less than 50°C (122°F). If certain conditions are met, a DTC is stored after the engine idles for 15 seconds (2 trip detection logic). This DTC is designed to monitor

© 2020-2026 Copyright www.tcorollacross.com PT NL