Toyota Corolla Cross: Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS
HINT:
Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the GTS when the ECM is in check mode. In check mode, the ECM uses 1 trip detection logic, which is more sensitive to malfunctions than normal mode (default), which uses 2 trip detection logic.
- Clear the DTCs.
- Change the ECM from normal mode to check mode using the GTS.
Click here .gif)
- Perform a simulation test.
Click here
- Check and wiggle the harness(es), connector(s) and terminal(s).
Click here
READ NEXT:
CAUTION / NOTICE / HINT When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by
REGISTRATION CAUTION / NOTICE / HINT PROCEDURE
1. VIN (VEHICLE IDENTIFICATION NUMBER) NOTICE: The Vehicle Identification Number (VIN) must be written to a replacement ECM.
HINT: The VIN is a 17-di
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an
SEE MORE:
DESCRIPTION When the light control switch is in the TAIL or HEAD position, the main body ECU (multiplex network body ECU) sends an illumination request signal to the headlight ECU sub-assembly LH/RH to illuminate the front side marker lights. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspe
DESCRIPTION The headlight ECU sub-assembly LH or headlight ECU sub-assembly RH stores a DTC if it detects an internal malfunction.
DTC No. Detection Item
DTC Detection Condition Trouble Area
B242C04 Headlight Control Module (Sub) System Internal Failure Detection condition:
