Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Basic Inspection

Toyota Corolla Cross (2022-2025) Service Manual / Engine & Hybrid System / M20a-fks (engine Control) / Sfi System / Basic Inspection

CAUTION / NOTICE / HINT

When a malfunction is not confirmed by the DTC check, troubleshooting should be carried out for all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following procedure, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.

PROCEDURE

1.

CHECK AUXILIARY BATTERY VOLTAGE

NOTICE:

Carry out this check with the engine stopped and the ignition switch off.

Result

Proceed to

11 V or higher

OK

Below 11 V

NG
NG

CHARGE OR REPLACE AUXILIARY BATTERY
OK

2.

CHECK WHETHER ENGINE CRANKS
NG

PROCEED TO PROBLEM SYMPTOMS TABLE

OK

3.

CHECK WHETHER ENGINE STARTS
NG

GO TO STEP 6

OK

4.

CHECK AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

(a) Visually check that the air cleaner filter element sub-assembly is not excessively contaminated with dirt or oil.

NG

REPLACE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
OK

5.

CHECK IDLE SPEED

(a) Check the engine idle speed.

Click here

NG

PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT
OK

6.

CHECK FUEL PRESSURE

(a) Check the fuel pressure.

Click here

NG

PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT
OK

7.

CHECK FOR SPARK

(a) Perform a spark test.

Click here

OK

PROCEED TO PROBLEM SYMPTOMS TABLE

NG

PROCEED TO PAGE AND CONTINUE TO TROUBLESHOOT

    READ NEXT:

     Registration

    REGISTRATION CAUTION / NOTICE / HINT PROCEDURE 1. VIN (VEHICLE IDENTIFICATION NUMBER) NOTICE: The Vehicle Identification Number (VIN) must be written to a replacement ECM. HINT: The VIN is a 17-di

     Initialization

    INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an

     Checking Monitor Status

    CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously m

    SEE MORE:

     Cellular Phone Registration Failure

    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Click here PROCEDURE 1. CHECK USAGE CONDITIONS (a) Check that the vehicle

     Components

    COMPONENTS ILLUSTRATION *A for Gasoline Model - - *1 PIPING CLAMP *2 SUCTION PIPE SUB-ASSEMBLY *3 SUCTION HOSE SUB-ASSEMBLY *4 DISCHARGE HOSE SUB-ASSEMBLY *5 AIR CONDITIONING TUBE AND ACCESSORY ASSEMBLY *6 O-RING

    © 2020-2025 Copyright www.tcorollacross.com PT NL