Toyota Corolla Cross: Camshaft Oil Control Solenoid
READ NEXT:
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (a) Connect the GTS to the DLC3.
(b) Turn the power switch on (IG). (c) Turn the GTS on. (d) Put the engine in I
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
15370
- -
INSPECTION PROCEDURE 1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistan
SEE MORE:
â– Opening the back door
Raise the back door while pushing
up the back door opener
switch.
â– Closing the back door
Lower the back door using a
back door handle, and then
push the back door from the outside
to close it.
Be careful not to pull the back
door sideways when using a
handle.
NOTICE
â
DESCRIPTION If the air inlet mode cannot be changed between recirculation/fresh or exhaust gas odors can be smelled even though recirculation mode is selected, the following factors may be the cause.
Symptom Factor
Air inlet mode cannot be changed between recirculation/fresh
On-vehicle Inspection
Opening/closing the back
door (vehicles without a
power back door)
