Toyota Corolla Cross: Brake Control Power Supply
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
PRECAUTION
-
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
NO. 1 BRAKE CONTROL POWER SUP
Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) i
SEE MORE:
DESCRIPTION Refer to DTC P034011. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P034031 Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal
Diagnosis condition:
The engine is running (600 rpm or more)
ON-VEHICLE INSPECTION PROCEDURE
1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the GTS to the DLC3.
(2) Start the engine. (3) Turn the GTS on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset / Fuel Pressure (High).
Removal
Camshaft Position Sensor "A" Bank 1 or Single Sensor No Signal (P034031)
