Toyota Corolla Cross: ABS Warning Light does not Come ON
DESCRIPTION
The skid control ECU (brake actuator assembly) controls the
ABS warning light in the combination meter assembly via CAN communication.
PROCEDURE
|
1.
|
INSPECT COMBINATION METER ASSEMBLY
|
(a) Perform the Active Test of the combination meter assembly using
the GTS.
Click here .gif)
Body Electrical > Combination Meter > Active Test
|
Tester Display
|
|
ABS Warning
|
(b) Check the combination meter assembly.
OK:
The ABS warning light turns on or off in accordance with GTS operation.
| OK |
.gif)
|
REPLACE BRAKE ACTUATOR ASSEMBLY
|
| NG |
|
INSPECT METER / GAUGE SYSTEM
|
READ NEXT:
DESCRIPTION
This procedure is for troubleshooting when the brake system
warning light (red indicator) remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the
DESCRIPTION
The skid control ECU (brake actuator assembly) controls the
brake system warning light (red indicator) in the combination meter assembly via
CAN communication.
PROCEDURE
DESCRIPTION
The brake hold standby indicator light turns on if brake hold
control is possible when the following conditions required for operation standby
are met and the brake hold switch (elect
SEE MORE:
REMOVAL
CAUTION / NOTICE / HINT
NOTICE:
To prevent the key from being locked in the vehicle, make sure to enter e-latch
inspection mode and enable the manual release handle before disconnecting the cable
from the negative (-) auxiliary battery terminal.
Click here
HINT:
When the cable is
OPERATION CHECK CHECK WINDSHIELD DEICER SYSTEM
(a) Turn the ignition switch to ON. (b) Check that the windshield deicer wire (windshield glass) becomes warm by operating the front wiper deicer switch.
(c) Confirm that windshield deicer system operation stops after approximately 15 minutes.
NOTICE
