Toyota Corolla Cross: Unlocking and locking the
doors from the inside
■ Door lock switches (to
lock/unlock)
.png)
- Locks all the doors
- Unlocks all the doors
■ Inside lock buttons
.png)
- Locks the door
- Unlocks the door
The front doors can be opened by
pulling the inside handle even if the
lock buttons are in the lock position.
■Locking the front doors from
the outside without a key
1. Move the inside lock button to
the lock position.
2. Close the door.
Vehicles without a smart key system
The door cannot be locked if the key
is in the engine switch.
Vehicles with a smart key system
The door cannot be locked if the
engine switch is in ACC or ON, or
the electronic key is left inside the
vehicle.
The key may not be detected correctly
and the door may be locked.
■Open door warning buzzer
If a door or the hood is not fully
closed, a buzzer will sound when
the vehicle speed reaches 3 mph (5
km/h).
The open door(s) or hood is indicated
on the multi-information display.
READ NEXT:
The door cannot be opened
from inside the vehicle when
lock is set.
Unlock
Lock
These locks can be set to prevent
children from opening the rear
doors. Push down on each rear
door switch to lock
The back door can be
locked/unlocked and
opened/closed by the following
procedures.
WARNING
Observe the following precautions.
Failure to do so may result
in death or serious injury.
■Before drivin
■ Smart key system (if
equipped)
Carry the electronic key to
enable this function.
Unlocks all the doors
The doors cannot be unlocked for 3
seconds after the doors are locked.
Locks all the do
SEE MORE:
REPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
(a) Turn the ignition switch ON. (b) Operate the compressor under the conditions shown below:
Item Condition
Operating time 3 minutes or more
Temperature setting Max cool
Blower speed High
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT DRIVER SEAT BELT WARNING LIGHT HINT: The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.
(a) Turn the ignition switch off. (b) Turn the ignition switch to ON.
(c) When the driver sea
