Toyota Corolla Cross: Steering Column Assembly
READ NEXT:
DISASSEMBLY
CAUTION / NOTICE / HINT
COMPONENTS (DISASSEMBLY)
Procedure
Part Name Code
1
UPPER STEERING COLUMN BRACKET W
INSPECTION
PROCEDURE
1. INSPECT PRELOAD
(a) Using a 10 mm hexagon socket wrench, install the steering wheel assembly
set bolt to the steering main shaft.
NOTICE:
Do not ap
REASSEMBLY
CAUTION / NOTICE / HINT
COMPONENTS (REASSEMBLY)
Procedure
Part Name Code
1
IGNITION OR STARTER SWITCH ASSEMB
SEE MORE:
DESCRIPTION
If the vehicle information stored by the skid control ECU (brake
actuator assembly) does not match that sent from the ECM or a new skid control ECU
(brake actuator assembly) is installed and the vehicle information has not been
stored, this DTC is stored.
DTC No.
TERMINALS OF ECU
CLEARANCE WARNING ECU ASSEMBLY
(a) Disconnect the I24 clearance warning ECU assembly connector.
(b) Measure the voltage and resistance on the wire harness side
connector according to the value(s) in the table below.
Terminal No. (Symbol)
Terminal Descri
Disassembly
ECM Communication (C124A00)
