Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Right Front Wheel Speed Sensor Incorrect Component Installed (C055695)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C055695

Right Front Wheel Speed Sensor Incorrect Component Installed

The front speed sensor RH is installed incorrectly.

Front Speed Sensor RH

PROCEDURE

1.

CHECK PART NUMBER (FRONT SPEED SENSOR RH)

(a) Check that the front speed sensor RH is installed.

OK:

Proper front speed sensor RH is installed.

NOTICE:

If it is necessary to remove components in order to check the front speed sensor RH, follow the relevant installation and removal procedures and precautions for those components.

NG

REPLACE FRONT SPEED SENSOR RH

OK

2.

CLEAR DTC

(a) Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs

(b) Turn the ignition switch off.

NEXT

3.

RECONFIRM DTC

(a) Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.

(b) Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes

Result

Proceed to

C055695 is not output

A

C055695 is output

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE FRONT SPEED SENSOR RH

    READ NEXT:

     Left Rear Wheel Speed Sensor Incorrect Component Installed (C055795)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area C055795 Left Rear Wheel Speed Sensor Incorrect Componen

     Right Rear Wheel Speed Sensor Incorrect Component Installed (C055895)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area C055895 Right Rear Wheel Speed Sensor Incorrect Compone

     Brake System Control Module "A" System Internal Failure (C059704)

    DESCRIPTION The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self-diagnosis. DTC No. Detection Item

    SEE MORE:

     Brake Warning Light Remains ON

    DESCRIPTION This procedure is for troubleshooting when the brake system warning light (red indicator) remains on but no DTCs are output. The skid control ECU (brake actuator assembly) controls the brake system warning light (red indicator) in the combination meter assembly via CAN communicat

     Inspection

    INSPECTION PROCEDURE 1. INSPECT FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition 1 - 2 20°C (68°F) 0.45 to 0.55 Ω If the

    © 2020-2025 Copyright www.tcorollacross.com PT NL