Toyota Corolla Cross: Propeller Shaft Assembly
READ NEXT:
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
FRONT FLOOR CENTER BRACE
575
DISASSEMBLY
CAUTION / NOTICE / HINT
COMPONENTS (DISASSEMBLY)
Procedure
Part Name Code
1
UNIVERSAL BOOT KIT
-
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Using a dial indicator, measure the runout of the intermediate shaft
assembly.
Maximum Runout:
SEE MORE:
DESCRIPTION Refer to DTC P062712. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P12D013 Fuel Pump Control (All Phase) Circuit Open
When the fuel pump control ECU operation duty ratio is 3 to 65%, an open is detected in the F
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT STOP LIGHT SWITCH ASSEMBLY (a) Disconnect the A53 stop light switch assembly connector.
(b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below.
Standard Voltage:
Tester Connectio
Removal
Fuel Pump Control (All Phase) Circuit Open (P12D013-P12D313)
