Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Front Radar Sensor System

Symptom

Suspected Area

Link

"System Stopped See Owner's Manual" is displayed

Vehicle Control History

"System Malfunction Visit Your Dealer" is displayed

Vehicle Control History

"System Stopped Front Radar Sensor Blocked Clean Radar Sensor" is displayed

Vehicle Control History

"System Stopped Front Radar Sensor Out of Temperature Range Wait until Normal Temperature" is displayed

Vehicle Control History

"System Stopped Front Radar In Self Calibration See Owner's Manual" is displayed

Vehicle Control History

    READ NEXT:

     Terminals Of Ecu

    TERMINALS OF ECU NOTICE: DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

     Freeze Frame Data

    FREEZE FRAME DATA DESCRIPTION (a) Whenever a front radar sensor system DTC is stored, the millimeter wave radar sensor assembly stores the current vehicle state as Freeze Frame Data. CHECK FREEZE

     Fail-safe Chart

    FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) If a malfunction is detected in the front radar sensor system, a message is displayed on the multi-information display and systems related to the malfuncti

    SEE MORE:

     Ambient Temperature Sensor Circuit Short to Ground (P007011)

    DESCRIPTION The thermistor assembly is installed in front of the cooler condenser assembly to detect the ambient temperature, which is used to control the air conditioning system. This sensor is connected to the air conditioning amplifier assembly and detects fluctuations in the ambient temperature.

     Inspection

    INSPECTION PROCEDURE 1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH (a) Check that the side turn signal light assembly LH. (1) Apply auxiliary battery voltage to the side turn signal light assembly LH and check that the light comes on. OK: Tester Connection Specified Condition

    © 2020-2026 Copyright www.tcorollacross.com PT NL