Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Precaution

PRECAUTION

GENERAL PRECAUTION

(a) The following conditions may be interpreted as a malfunction even though they are normal operation:

  1. An object is placed on the front passenger seat and the system judges that an adult is seated. As the occupant classification system detects and classifies occupants based on weight, the system may detect an object placed on the seat cushion as an adult front passenger depending on its weight.
  2. Pressure is applied to the front passenger seat and the system judges that an adult is seated. As the occupant classification system detects and classifies occupants based on weight, the system may detect an adult front passenger if pressure is applied to the seat cushion by hands, etc.
  3. Illumination of the passenger airbag ON/OFF indicator does not change immediately after a front passenger is seated or leaves the vehicle. To prevent the classification judgment from changing when a front passenger changes their seating posture, a certain amount of time is required to detect and classify an occupant when the calculated weight changes. Therefore, there will be a time lag between when a front passenger is seated or leaves the vehicle and when the system detects the occupant.

(b) Zero point of the occupant classification sensors may deviate. To ensure sensor accuracy, be sure to perform Zero Point Calibration.

Click here

PRECAUTION WHEN REPLACING AIRBAG ECU ASSEMBLY

(a) When the airbag ECU assembly is replaced, perform zero point calibration for the yaw rate and acceleration sensor.

Click here

HINT:

The yaw rate and acceleration sensor is built into the airbag ECU assembly.

(b) When the airbag ECU assembly is replaced, update the ECU security key.

Click here

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *2 MAP LIGHT ASSEMBLY - PASSENGER AIRBAG ON/OFF INDICATOR ILLUSTRATION *1 AIRBAG ECU AS

     System Diagram

    SYSTEM DIAGRAM Communication Table Transmitting ECU / Parts (Transmitter) Receiving ECU (Receiver) Signal Communication Method Passenger Seat Buckle Switch (Front Seat Inn

     System Description

    SYSTEM DESCRIPTION GENERAL (a) The airbag ECU assembly estimates the weight of an occupant based on signals received from the 2 occupant classification sensors. The airbag ECU assembly determines whet

    SEE MORE:

     Safety Connect LED light Indicators

    When the engine switch is turned to ON, the red indicator light comes on for 2 seconds then turns off. Afterward, the green indicator light comes on, indicating that the service is active. The following indicator light patterns indicate specific system usage conditions: Green indicator light on =

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 REAR AXLE HUB AND BEARING ASSEMBLY 42450B - - 2 INSTALL

    © 2020-2025 Copyright www.tcorollacross.com PT NL