Toyota Corolla Cross: System Description
SYSTEM DESCRIPTION
GENERAL
(a) The airbag ECU assembly estimates the weight of an occupant based on signals received from the 2 occupant classification sensors. The airbag ECU assembly determines whether the front passenger seat is occupied and classifies the occupant based on the estimated weight, front passenger side buckle switch state, acceleration sensor signal and vehicle speed signal.
(b) The airbag ECU assembly controls the operation of the passenger airbag ON/OFF indicator and restricts the operation of the instrument panel passenger without door airbag assembly.
READ NEXT:
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the occupant classification system.
*: Use the GTS.
PROCEDURE
1. VEHICLE BROUGHT TO WORKSHOP
OPERATION CHECK CHECK SRS WARNING LIGHT (a) Primary check
(1) Turn the ignition switch to ON and check that the SRS warning light turns on.
(2) Turn the ignition switch off. Wait for at least 2 s
INITIALIZATION DESCRIPTION (a) Zero point of the occupant classification sensors may deviate in the following situations. To ensure sensor accuracy, be sure to perform Occupant Detection Sensor Zero P
SEE MORE:
PARTS LOCATION
ILLUSTRATION
*1
TCM
*2
ECM
*3
BRAKE ACTUATOR ASSEMBLY
- SKID CONTROL ECU
*4
NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY
ILLUSTRATION
*1
TRANSMISSION VALVE
DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING GTS (STEERING ANGLE SENSOR)
(a) Read the Data List according to the display on the GTS. Chassis > Steering A
