Toyota Corolla Cross: On-vehicle Inspection

Toyota Corolla Cross (2022-2026) Service Manual / Engine & Hybrid System / M20a-fks (engine Control) / Camshaft Oil Control Solenoid / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

(a) Connect the GTS to the DLC3.

(b) Start the engine.

(d) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 1.

Powertrain > Engine > Active Test

Tester Display
Control the Exhaust VVT OCV Duty Ratio Bank 1

(e) According to the display on the GTS, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly.

Standard Condition:

GTS Operation	Engine Condition
0%	Normal engine speed
100%	Engine idles roughly or stalls

HINT:

Refer to "Data List / Active Test" [Exhaust VVT Hold Learn Value Bank 1, Exhaust VVT Change Angle Bank 1, Exhaust VVT OCV Control Duty Ratio Bank 1 and Exhaust VVT Target Angle Bank 1].

Click here

If the result is not as specified, check the cam timing oil control solenoid assembly, wire harness and ECM.

SEE MORE:

Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the GTS to read the Data List allows the values or states of sw

Drive Belt

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT V-RIBBED BELT (a) Check the V-ribbed belt for wear, cracks or other signs of damage. HINT: If any of the following defects is found, replace the V-ribbed belt. The V-ribbed belt is cracked. The V-ribbed belt is wo

Toyota Corolla Cross: On-vehicle Inspection

READ NEXT:

Removal

Inspection

Installation

SEE MORE:

Data List / Active Test

Drive Belt