Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT ACTUATOR MOTOR OPERATION

(a) Turn the motor relay on and check for actuator motor operation sounds.

Chassis > Brake/EPB > Active Test

Tester Display

Motor Relay

NOTICE:

Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, wait an interval of more than 20 seconds between operations.

(b) Turn the motor relay off.

(c) Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the initial brake pedal depth is maintained for the entire 15 seconds.

(d) Turn the motor relay on and check that the brake pedal does not pulsate.

NOTICE:

Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, wait an interval of more than 20 seconds between operations.

(e) Turn the motor relay off and release the brake pedal.

2. INSPECT FRONT RIGHT WHEEL OPERATION

(a) Depress the brake pedal and hold it.

NOTICE:

Do not turn on a solenoid in a manner different than that shown in the following steps.

(b) Turn the SFRH and SFRR solenoids on simultaneously and check that the brake pedal cannot be depressed further.

Chassis > Brake/EPB > Active Test

Tester Display

ABS Solenoid

NOTICE:

Each solenoid operates for 2 seconds and turns off automatically. If a solenoid needs to be operated repeatedly, wait an interval of more than 20 seconds between operations.

(c) Turn the SFRH and SFRR solenoids off simultaneously and check that the brake pedal can be depressed.

(d) With the brake pedal still depressed, turn the motor relay on and check that the brake pedal rises.

Chassis > Brake/EPB > Active Test

Tester Display

Motor Relay

NOTICE:

Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, wait an interval of more than 20 seconds between operations.

(e) Turn the motor relay off and release the brake pedal.

3. INSPECT OTHER WHEEL OPERATION

(a) Using the same procedure, check the solenoids for the other wheels.

HINT:

  • Front left wheel: SFLH, SFLR
  • Rear right wheel: SRRH, SRRR
  • Rear left wheel: SRLH, SRLR

    READ NEXT:

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 PRECAUTION -

     Installation

    INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION) Procedure Part Name Code 1 BRAKE ACTUATOR BRACKET CUSHIO

     Brake Actuator (for Hev Model)

    SEE MORE:

     Passenger Seat Occupant Classification Sensor "A" Signal Bias Level Out of Range / Zero Adjustment Failure (B00C028)

    DESCRIPTION DTC B00C028 is also stored when the front seat assembly RH is subjected to a strong impact, even if an actual accident did not occur. DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode B00C028 Passenger Seat

     Inspection

    INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR CAUTION: Do not put your hands into the water that has been heated for the inspection. Touching the heated water could result in burns. (a) Measure the resistance according to the value(s) in the table below.

    © 2020-2025 Copyright www.tcorollacross.com PT NL