Toyota Corolla Cross: Brake Actuator (for Hev Model)
READ NEXT:
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following m
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
PRECAUTION
-
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
BRAKE ACTUATOR BRACKET CUSHIO
SEE MORE:
DESCRIPTION The air conditioner pressure sensor, which is installed to the high pressure side pipe to detect refrigerant pressure, sends a refrigerant pressure signal to the air conditioning amplifier assembly. The air conditioning amplifier assembly converts this signal to a pressure value accordin
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during cylinder head gasket removal/installation are shown below. Necessary Procedures After Parts Removed/In
On-vehicle Inspection
Refrigerant Pressure Sensor Circuit Short to Ground (P053011)
