Toyota Corolla Cross: Oil Level Sensor
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 ENGINE UNDER COVER ASSEMBLY
51410 -
- -
Procedu
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 ENGINE OIL LEVEL SENSOR
89491
- -
2 OI
SEE MORE:
INITIALIZATION INITIALIZE MULTIPLEX NETWORK DOOR ECU
NOTICE: Initialization of the multiplex network door ECU (back door initial position learning) is necessary if the following work procedures are performed while the back door is open.
The cable to the negative (-) auxiliary battery terminal is
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
(a) Disconnect the T12 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harne
Removal
Initialization
