Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Does not Recognize Voice Commands Performed to Contact Support Center

Toyota Corolla Cross (2022-2026) Service Manual / Audio & Visual & Telematics / Telematics / Telematics System / Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.

CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

OK

END

HINT:

Voice recognition may be difficult due to the speech condition, incompatible phrases, or differences between speakers.
NG

CONTACT SERVICE CENTER

    READ NEXT:

     Remote Engine Starter does not Operate

    CAUTION / NOTICE / HINT NOTICE: Before replacing the certification ECU (smart key ECU assembly), refer to smart key system (for Entry Function) Precaution. for HEV Model: Click here for

     DCM Data Signal Circuit between Radio Receiver and DCM

    DESCRIPTION This circuit is used to send and receive signals between the DCM (telematics transceiver) and the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1.

     Warning Notification Function Malfunction

    PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function.

    SEE MORE:

     Air Inlet Damper Control Servo Motor Actuator Stuck Off (B143B7F)

    DESCRIPTION The No. 1 blower damper servo sub-assembly sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on these signals to move the air inlet damper to the appropriate

     Idle Control System (P050500)

    DESCRIPTION The idle speed is controlled by the electronic throttle control system. The electronic throttle control system is comprised of: 1) one valve type throttle body with motor assembly; 2) the throttle actuator, which operates the throttle valve; 3) the throttle position sensor, which detects

    © 2020-2026 Copyright www.tcorollacross.com PT NL