Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Remote Engine Starter does not Operate

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the certification ECU (smart key ECU assembly), refer to smart key system (for Entry Function) Precaution.

  • for HEV Model:

    Click here

  • for Gasoline Model:

    Click here

PROCEDURE

1.

CHECK SMART KEY SYSTEM (for Start Function)

(a) Check that the engine can be started by pressing the ignition switch.

Result

Proceed to

Engine can be started.

A

Engine cannot be started.

B

B

GO TO SMART KEY SYSTEM (for Start Function)

  • for HEV Model:

    Click here

  • for Gasoline Model:

    Click here

A

2.

REGISTRATION

HINT:

If registration is not performed after replacing any of the following parts, the remote engine start and stop will not be available.
  • Certification ECU (smart key ECU assembly)
  • DCM (Telematics Transceiver)

(a) Perform remote engine start and stop registration.

  • for HEV Model:

    Click here

  • for Gasoline Model:

    Click here

(b) Check if the problem symptom recurs.

Result

Proceed to

System does not return to normal.

A

System returns to normal.

B

A

CONTACT TOYOTA CONNECT SUPPORT CENTER

B

END (COMMUNICATION ID REGISTRATION WAS NOT PERFORMED)

    READ NEXT:

     DCM Data Signal Circuit between Radio Receiver and DCM

    DESCRIPTION This circuit is used to send and receive signals between the DCM (telematics transceiver) and the radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1.

     Warning Notification Function Malfunction

    PROCEDURE 1. CHECK PROBLEM SYMPTOM (WARNING NOTIFICATION FUNCTION) (a) Check the problem symptom. (1) Check the problem symptom of the warning notification function.

     Remote Service Malfunction

    PROCEDURE 1. CHECK CAN COMMUNICATION SYSTEM (a) Enter the following menus: Bus Check. for HEV Model: Click here for Gasoline Model: Click here (b)

    SEE MORE:

     Terminals Of Ecu

    TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the I24 clearance warning ECU assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Terminal Descri

     Customize Parameters

    CUSTOMIZE PARAMETERS NOTICE: When the customer requests a change in a function, first make sure that the function can be customized. Be sure to make a note of the current settings before customizing. When troubleshooting a function, first make sure that the function is set to the defa

    © 2020-2025 Copyright www.tcorollacross.com PT NL