Toyota Corolla Cross: M20a-fxs (lubrication)
READ NEXT:
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. CHECK ENGINE OIL LEVEL (a) Warm up and stop the engine, then wait for 5 minutes.
(b) Check that the engine oil level is between the low leve
ComponentsCOMPONENTS ILLUSTRATION
*1 OIL FILTER SUB-ASSEMBLY
*2 OIL FILLER CAP ASSEMBLY
*3 GASKET
*4 OIL PAN DRAIN PLUG
*5 CENTER NO. 4 ENGINE UNDER COV
SEE MORE:
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalysts and evaporative emissions (EVAP) systems.
The monitor result allo
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator
assembly) receives a +B line open signal from the steering sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C14FE14
Steering Angle S
