Toyota Corolla Cross: M20a-fks (lubrication)
READ NEXT:
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. CHECK ENGINE OIL LEVEL (a) Warm up and stop the engine, then wait for 5 minutes.
(b) Check that the engine oil level is between the low leve
ComponentsCOMPONENTS ILLUSTRATION
*1 OIL FILTER SUB-ASSEMBLY
*2 OIL FILLER CAP ASSEMBLY
*3 GASKET
*4 OIL PAN DRAIN PLUG
*5 CENTER NO. 4 ENGINE UNDER COV
SEE MORE:
InspectionINSPECTION PROCEDURE
1. INSPECT FLOW SHUTTING VALVE (WATER VALVE) (a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - 2 20°C (68°F)
22 to 28 Ω If the result
Components
COMPONENTS
ILLUSTRATION
*1
FRONT DRIVE SHAFT OIL SEAL LH
*2
FRONT DRIVE SHAFT OIL SEAL RH
●
Non-reusable part
-
-
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The neces
