Toyota Corolla Cross: Oil Level Sensor
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 ENGINE UNDER COVER ASSEMBLY
51410 -
- -
2 DRAIN E
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 ENGINE OIL LEVEL SENSOR
89491
- -
2 OI
SEE MORE:
DESCRIPTION The certification ECU (smart key ECU assembly) generates a request signal and transmits the signal to the front door outside handle assembly RH (electrical key antenna) at intervals of 0.25 seconds. For the front door outside handle assembly RH (electrical key antenna) to detect when the
INSPECTION PROCEDURE 1. INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for 2WD)
(a) Preparation for check. (1) Confirm the standard, high and low positions of the link that will be used in the following inspection.
The standard position is 53° from the maximum link angle (high) and 113° f
Removal
Front Passenger Side Electrical Antenna Circuit Open (B27A213)
