Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Left Front Wheel Speed Sensor Incorrect Component Installed (C055595)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C055595

Left Front Wheel Speed Sensor Incorrect Component Installed

The front speed sensor LH is installed incorrectly.

Front speed sensor LH

PROCEDURE

1.

CHECK PART NUMBER (FRONT SPEED SENSOR LH)

(a) Check that the front speed sensor LH is installed.

OK:

Proper front speed sensor LH is installed.

NOTICE:

If it is necessary to remove components in order to check the front speed sensor LH, follow the relevant installation and removal procedures and precautions for those components.

NG

REPLACE FRONT SPEED SENSOR LH

OK

2.

CLEAR DTC

(a) Clear the DTCs.

Chassis > Brake/EPB > Clear DTCs

(b) Turn the ignition switch off.

NEXT

3.

RECONFIRM DTC

(a) Based on the Freeze Frame Data and interview with the customer, attempt to reproduce the conditions when the malfunction occurred.

(b) Check if the same DTC is output.

Chassis > Brake/EPB > Trouble Codes

Result

Proceed to

C055595 is not output

A

C055595 is output

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE FRONT SPEED SENSOR LH

    READ NEXT:

     Right Front Wheel Speed Sensor Incorrect Component Installed (C055695)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area C055695 Right Front Wheel Speed Sensor Incorrect Compon

     Left Rear Wheel Speed Sensor Incorrect Component Installed (C055795)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area C055795 Left Rear Wheel Speed Sensor Incorrect Componen

     Right Rear Wheel Speed Sensor Incorrect Component Installed (C055895)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area C055895 Right Rear Wheel Speed Sensor Incorrect Compone

    SEE MORE:

     Generator Position Sensor Internal Electronic Failure (P1CAC49,P1C641F,P1CAF38)

    DESCRIPTION The motor generator control ECU (MG ECU), which is built into the inverter with converter assembly, monitors its internal operation and detects malfunctions. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate Note P1C6

     Terminals Of Ecu

    TERMINALS OF ECU CLEARANCE WARNING ECU ASSEMBLY (a) Disconnect the I24 clearance warning ECU assembly connector. (b) Measure the voltage and resistance on the wire harness side connector according to the value(s) in the table below. Terminal No. (Symbol) Terminal Descri

    © 2020-2025 Copyright www.tcorollacross.com PT NL