Toyota Corolla Cross: Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|
1 - 2 | 20°C (68°F) |
29 to 30 Ω |
If the result is not as specified, replace the fuel vapor containment valve (fuel tank solenoid main valve assembly).
READ NEXT:
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 FUEL VAPOR CONTAINMENT VALVE (FUEL TANK SOLENOID MAIN VALVE ASSEMBLY)
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT PCV VALVE (VENTILATION VALVE SUB-ASSEMBLY)
(a) Check the PCV valve (ventilation valve sub-assembly) operation.
(1) Start the
RemovalREMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 2 FUEL VAPOR FEED HOSE
23827A -
- -
2 FUEL V
SEE MORE:
The following procedures
may be used to start the
engine if the vehicle's battery
is discharged.
You can also call your Toyota
dealer or a qualified
repair shop.
Restarting the engine
If you have a set of jumper (or
booster) cables and a second
vehicle with a 12-volt battery,
you can jump start you
ON-VEHICLE INSPECTION PROCEDURE
1. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY Click here
2. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (EXHAUST CAMSHAFT TIMING GEAR BOLT ASSEMBLY)
(a) Check the stroke of the plunger in the center of the camshaft timing oil control valve asse
